The purpose of this simple guide is to help you install a Panda Breath Chamber Heater into your Elegoo Centauri Carbon 1. The Panda Breath is not directly made for the Centauri Carbon, however you can still use it as intended.

1. Carefully remove the left side panel of your Elegoo Centauri Carbon, there are 8 screws holding it on, then remove the 6 screws on the back panel of your Panda Breath.

2.  Once both panels removed, line your guide up with the bottom-left corner of the panel. Make sure the 10mm side of the guide is vertical & the 7mm side is against the bottom of the panel.

3.  Before drilling find a drill bit that fits in one of the PB holes (if I find the bit I used I will update this post). Drill either 5 or 6 holes through the panel, depending on your setup. I only drilled 5 holes because I was unable to drill it out without my press, but 5 works just as well.

4. After drilling the holes, clean up the sharp edges so you can properly line up the PB in your ECC.

5. Place your PB on the inside of the panel and then insert your hardware (M3X0.5 6mm). Before you fully seat your chamber heater, you should carefully reinstall the left panel hardware so you can properly align both the panel and the PB. Once in place you can snug everything down.

6. Now that your PB is installed, you need to power it. I snaked my cable up and over my PB and up through the back left corner riser as seen in the photo. 

Also there are two files that I included, they are for your pereferance depending on which side you want to drill from.

Panda Breath:

Centauri Carbon:

M3X0.5:

Riser:

Left Corner Riser: