This is a pod for a webcam, i used the Logictec C-170-webcam. It is used with Octoprint and is installed on a IKEA LACK-table.
The stage one and two are put together with tow screws and two nuts. on the bottom you need two wood-screws for the pod, and two wood screws for the stabilization-thing.

The stage 2-thing has a half-sphere and two very small holes, so you can put aluminium foil inside the sphere and put a small 12-v-led-lamp with 0,7mm-wires. The wires can be put through the holes and can be soldered to power supply, so you have a nice lighting of your print area.

CTC DIY Prusa-clone

No

No

0,25

100%

This was created with freecad, and the file is also contained.