Summary

This box will house the Easy Receiver from Pacific Antenna. It uses the BNC, speaker connector, 9 volt battery connector and Knobs supplied by Pacific Antenna. Used #4 x 1/4 inch self tapping screws or you can use #4x32 screws, the screw holes are threaded. The power switch is a mini toggle switch with 6mm threaded shaft (Amazon: Gebildet SPST Mini Toggle 2 terminal 2 position switch). Added a back up washer to the audio connector (Amazon: Uxcell M6mmx1mm stainless steel flat washer).

I printed the lid in two colors in order to highlight the text. I use a Creality CR10-S printer with Cura. I added a filament change at layer number 11.

There are two cases to pick from, indented or extruded text. Your choice, whatever works best for you. I printed the box with the bottom on the build plate. I did use supports on the extruded text to support the text.