The detachable magnetic filter of the Lancool 207 case.

This filter covers the large hole at the back of the chassis. It prevents the 2x120mm bottom fan from sucking in dust. It is easy to install and remove.

Materials list:

• 29 round magnets
• Nylon filter net

Print settings:

Nozzle: 0.4 mm; Layer height: 0.2 mm; Infill: 100%; Filament materials: PLA, PETG, etc.

Steps:

1. Place the model in the direction shown in the first picture in the slicing software.
2. After slicing the model, add a pause at the seventh layer
3. When printing is paused, put the magnets into the holes. They should slide in without any friction.
4. Use a magnet to stretch the nylon net to the top of the print.
5. Resume printing.
6. Cut off the excess net.

Installation:Remove the right side panel of the chassis and place the filter into the chassis. Rest it against the hexagonal grid.