Misc Notes
Modular magnet strip for garage kitchen etc. Meant to fit magnet strips you can get on Amazon. They are 10mm X 60mm. I made it modular so make it longer or shorter depending on where you want to mount it. Print, slide the strips in the slots (No glue needed for this step, held by friction) Then glue modules w superglue. Do the same for the ends. I used #8 X 1 inch wood screws, using appropriate drywall anchors. (If its solid wood, no anchors needed) Depending on your printers tolerance you may have to massage the parts to fit.

Only place you need supports is the small pins on the end of the Mag end w pins. All others print no supports.