Using jandajanda's base, this switch case version improves in a few areas that I found helpful/needed.

In case you want to print from scratch or don't care about having the Redbox logo/arrows on top, here are the print settings I used for minimal material use while still getting a good quality result.

Print Settings

• Layer height: 0.2mm
• Wall generator: Classic
• Detect thin walls: Enabled
• Wall loops: 3
• Top/Bottom shell layers: 2
• Top/Bottom shell thickness: 0
• Infill density: 10%
• Infill type" Gyroid

Everything else was left at defaults