This is a lightsaber designed to go on the bottom of your drumstick, to turn the stick into a blade.

PAY ATTENTION TO THIS* --> This model will download sized for a 2a (16mm diameter) drumstick. This is the thickest size, so once it is loaded in the slicer, scale it to these percentages depending on your A rating:

5a- 90%

7a- 93.75%

2B- 100% 

I recommend using Overature LW PREFOAMED PLA for this, but any filament will work. (Overature has the best weight to durability ration THAT I'VE TESTED)

Print speed is optional, since the filament is already foamed, speed didn't effect the print quality for me.

Print temperature should be as usual for most PLA's at 195-210 degrees C

TREE SUPPORTS RECCOMENDED

For a good strength to durability ratio, I recommend anywhere between 15% to 25% infill

Lastly, I don't know how many people pay attention to what glue they use, as long as it sticks, but PLA gloop, Gorilla Glue (any type) or a 3D pen for welding is highly recommended for not just this print, but any future prints of yours. Super glue does not stick well to Overature filaments well for some reason.

Feel free to print and sell these in your workplace or school! And spread the word on where to find these because I will be uploading more hilts!