Summary

VF: Hi then it's a bit of shit this files so if you have quetions ask me.
cut the file to print there is the body (Assembly 3 - block pile-1) and for the cap it is up to you to see if you want that there is a little bit of material to balance the grip or not .
Anyway, I don't have any preference for the file (2+ pod and Cap 2 flat) are rotten in a place just because of a file. The thing is that I originally modeled on Solidworks but there had a shit and I could not modify the file that on Sketchup or the aspeu degeullasse of one of the studs but do not worry it's done the taff anyway.

EN: Hi then it's a bit of shit this files so if you have quetions ask me.
cut the file to print there is the body (Assembly 3 - block pile-1) and for the cap it is up to you to see if you want that there is a little bit of material to balance the grip or not .
Anyway, I don't have any preference for the file (2+ pod and Cap 2 flat) are rotten in a place just because of a file. The thing is that I originally modeled on Solidworks but there had a shit and I could not modify the file that on Sketchup or the aspeu degeullasse of one of the studs but do not worry it's done the taff anyway.

PS: Les trous de chaque côté sont fait pour mettre une bande velcro qui fait le tour et permettre de fermer et ouvrir la boite a volontée

PS: The holes on each side are made to put a velcro band that goes around and allow to close and open the box at will