Summary

Model V1 has a wider bottle neck than V2.
I think V2 fits a little better at the neck of the bottle, but you can also adjust the neck of a bottle later by heating it with a hairdryer if you want to.

You need a slicer for the model that generates a tree support. I used Bambu Studio.
Here, I had to construct something on the ground so that the part of the bottle would stay in the air.

I've created V3, but I tried to pull the model from the support.
Next time, I will keep it in place.

Today, I created V4. It's a bit smaller, but it fits better on the neck of the bottle.

I also sometimes had a slightly different tree support again by simply repositioning the model or the angle of the model to the build plate.

I love this model. I hope you do too ;)

Here is my Instagram post for this model:
https://www.instagram.com/p/Cs4A_7sNH57/?igshid=MzRlODBiNWFlZA==

Print Settings

Printer:

Bambulab X1C

Rafts:

No.

Supports:

Yes

Resolution:

0.200

Infill:

15%

Filament: Bambulab PLAMetal Green