A stand for an old LCD screen, adding a cheap extra scree to workplace.

Parts  

• M4 bolts an nuts, 
• a long M6 screw, 70 mm plus nut for squeezer
• parkers for base
• old tent pole (outer diameter 19.5 mm), 2 times 40 cm

All joints can be tightened with screws, to fix position, I leave them rather loose so position can be manuallt adjusted when needed.  Can adjust height, tilt, rotate, and can change from landscape mode to portait mode. 

Print all stl files once, screen clamp needs be printed twice.

Can be printed without support, except for cross. 

Can be directly screwed to desk, o on small wooden plank, (appx. 20 X 30 cm)

By squeezing both parts of squeezing mechanism together inside pole, the lower one expands and and grips the pole. 

Designed in Shapr3D on ipad