Case for a Raspberry Pi 3 Mediacenter

The "hole" in the top is for a Infrared Receiver breakout connected via GPIO.

I must admit, the LED's aren't functional yet. The idea was to have a set of shell scripts to signaling different system states with different pattern.
Boot up, shutdown, Kodi running, VDR running.
And a dedicated plugin for Kodi/VDR to show the current state, play, pause, stopped, forward, rewind, and so on.
There is existing a bare minimum draft, but due less time it's not even an pre alpha.

The additional Arduino and the big 15Amps power supply on the picture is for he main ambilight with ~192LED's.
But maybe the space occupied from the power supply could be used for a HDD/SSD.

There are a few things that could be optimized, all connections to the back, a few vents.

But source is attached.

Print instructions

Printed in PLA, translucent front in clear PETG.

Top part was printed upside down.
Supports were used for the main part, it would be a to much bridging without.