Anet A8 Quick-Change Spoolholder
EmeraldFrog
AI找相似
打印配置(0)
模型文件(0)
0
0
0
发布时间:2025-12-01 23:02:04
0
0
000描述
标签
模型来源
评论(0)
This mashup of two existing designs speeds up filament changes. No fasteners need to be done or undone; just slide the spool onto or off of the roller. Bearings minimize friction in the roller.
Print Settings
Printer Brand:
Anet
Printer:
A8
Rafts:
No
Supports:
No
Resolution:
0.2 mm
Infill:
20%
Filament: 3D Solutech PLA real green & real blue
Notes:
Print the spool holder and the 70-mm roller (the 96-mm roller is too long). Insert 608ZZ bearings in the ends of the roller.
Mount the spool holder over the left side of the frame through; you'll probably need to replace the original screws with longer screws.Use the M8 threaded rod, nuts, and washers from the stock A8 spoolholder: bolt it to the new spoolholder with most of the length facing forward, then slide the roller onto the rod and secure it with a nut.
标签
模型来源
原设计地址: 点击查看
CC-BY