This is my last release in 2025, the WiiMote Guncon!

 

Three parts, clamped together, are designed to be printed without the need for support.

 

I admit that I made it in the simplest way possible, aiming to minimize the printing workload. Therefore, a version 2 with more parts and greater depth will be needed in the future.

 

I use a smooth printing board for printing, so my prints adhere very well. If you use a textured printing board, you may need to use a brim to prevent small details from moving during the first few layers.

 

I used the excellent Wesk to scan the documents [https://bitbuilt.net/forums/threads/ps1-guncon-lightgun-scan.4124/] As a reference, this is very helpful for placing details in the correct position; unfortunately, some compromises have been made, such as the small text. Its size and position are correct, but the clarity has decreased as a result. I plan to keep it as it is. I could increase its size, but I think that would make it too prominent.

 

I tried to reduce the inherent thickness when making it this way by tilting the front of the WiiMote to the bottom of the handle. I think this helped, but if I were to do it again, I might increase the angle by one or two degrees. Or, as I did before, by bolting the individual parts together.

 

Anyway, I hope you have a great time and...

 

Someone has been kidnapped! It's Rachel.
The daughter of President Sertia!

 

My PATREON and PATREON store.
https://www.patreon.com/3DFreeman

Thank you for your continuous support!

=)