Changes from the Original

• The bottom part of the CHEETAH enclosure is split into two to achieve a total width of 380mm.

Assembly

• This uses the same screws as the original CHEETAH

Printing Suggestions

• 4 Walls / 20% Cubic Infill / No Supports
• Set “Top Surface” to 80% to ensure there is no over-extrusion, and to achieve a very smooth surface.  Or use ironing--if you have it dialed in.
• Only tested in PLA, but other materials should work--provided they have minimal warping/shrinkage
• Designed for 220mm x 220mm x 250mm build volume
• The flattest part of the model should face the bed
• Recommend an enclosed 3d printer.  The sharp corners of the body will likely lift from the build plate as the filament cools.  Additionally ensure good adhesion to the build plate.
• Or, use mouse ears on the sharp corners.

MISC

• Also compatible with the non-OS version of the CHEETAH.