Holder for PT Level
Leah Allen
AI找相似
打印配置(0)
模型文件(0)
0
0
0
发布时间:2026-02-15 00:06:18
0
0
000描述
模型来源
评论(0)
I have a cistern and use a PT Level to monitor it (www.ptlevel.com) and wanted a decent way to hold it (other than 2 sticks haphazardly stuck in the ground) . The cap is 170mm across.
I have uploaded version 3 as version 2 the bars finally broke off. I made it a little shorter and added some support to the bars so they are not flimsy anymore.I also changed the following: increase fill to 50% Wall thickness was 1.6 speed was 60 Had Feline printing supervision (see photos)
Print Settings
Printer Brand:
Prusa
Printer:
Prusa Clone
No
Supports:
No
.2 layer height
Infill:
30%
Notes:
I used a .8 nozzle and .2 layer height with .8 wall thickness and it seems sturdy. I had print speed set to 70 but had to slow it down when printing the angle as well as the thinner parts at the top. Nozzle heat was 240 and bed was at 85 printed on Polyimide tape (PetG loves this stuff)
模型来源
原设计地址: 点击查看
CC-BY