A5 2016 case
solid_utensil
AI找相似
打印配置(0)
模型文件(0)
0
0
0
发布时间:2025-12-10 20:37:09
0
0
000描述
标签
模型来源
评论(0)
My phone was broken so I switched to this phone temporarily but couldn't find a case for it. So I made one. Has all the proper holes (even the top microphone)
Update: V2 is out, which has a better fit, making it snap into place with a satisfying click. Its a bit (1mm-->1.2mm) thicker but it is not noticeable.
Update2: V3 is out which fixes the charging port, it has a better fit again, moves the mic hole to line it up better, it's also stronger where the sides and the back connect, and some minor aesthetic tweaks.
Print Settings
Printer:
Lotmaxx Sc-10 Shark V2
Rafts:
No
Supports:
No
Resolution:
200
Infill:
20
Filament:
Esun PLA+Red
Notes:
No supports needed. Just rotate the part 180 degrees. Turn off combing in cura. It adds a lot of unnecessary moves that makes the print come out worse
标签
模型来源
原设计地址: 点击查看
CC-BY