A bracket to hold the IMX291 camera module that takes the place of (and reuses the same screws) as the IR LED board that comes in the below enclosure.  Holds the end of the 6mm lens about 1mm off the front glass.  Utilizes some M2 threaded inserts and M2 screws for the mounting of the sensor, other than that the enclosure just needed some silicone to seal up a few holes and a drilled hole for the cable gland/POE cable.

https://www.aliexpress.com/item/1005005256875908.html?spm=a2g0o.order_list.order_list_main.76.15c11802QlWeqF&gatewayAdapt=vnm2glo

Printed in PETG, the enclosure will get hot in the sun.