Hi friends,

I don't know for you but I'm always using a phone support. 3D printing is a real pleasure for that kind of use.

There are many on Tingiverse but I created my own with my personal requierments.

So, I present you My Eggy Phone Support, the egg shaped support. I made it with 2 ideas: a small support and multiple inclinations.

With MEPS, you can use your phone in portrait or landscape, vertically or at 20° or 45°.

The protrusion on one side, opposite to the 45° nick is not intended to put the support on the wall but to avoid a fall with long phones !

I made a low size version (20 mm) with a place to put the usb cable, if needed, in landscape position.

I made a taller (60 mm) version to allow the use of usb cable in portrait mode.

That is simple but I use it every day for months and I am happy with. Hope you will be too.

December 3,2018: For faster print, I've added a basic version without place for cable at the center.

Bonjour chez vous.

Print Settings

Printer Brand:

Prusa

Printer:

Rafts:

No

Supports:

Resolution:

0.2mm

Infill:

Notes:

I made with 20% infill but 10% works fine too.

Category: Mobile Phone