Soundbar Mount
NancyPearson
AI找相似
打印配置(0)
模型文件(0)
0
0
0
发布时间:2026-04-14 08:04:10
0
0
000描述
标签
模型来源
评论(0)
This is a soundbar mount to connect the Polk Audio Signa S2 soundbar to my Walmart special Sanyo 55 inch tv. This helps get the soundbar mounted to the tv so that when the tv is angled with the wall mount, the center channel also moving with it.
This should be a good starting point if you have a similar situation for your soundbar and tv. I used the holes where the feet mounted to attach the one side of the bracket.
Modify as needed as my case is very specific and may not match yours.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
Yes
Resolution:
0.3
Infill:
50-80%
Filament:
AMZ3D PETG, ABS
Notes:
Going as high as double on the line width will make this print stronger as well as increasing the layer height as much as possible to get strong layers has led to a strong print. Also increasing your number of walls setting vs increasing infill creates a stronger part in my experience, so you can go with 50% infill but use 6-8 walls to create a very strong part.
You will need to mirror the bracket on the smaller flat side near the speaker mount hole. This can be done in cura.标签
模型来源
原设计地址: 点击查看
CC-BY