This is a two-part camera mount for the SO-101 arm. I don't have an SO-100—if you decide to print it, let me know if it worked for the SO-100.

The top part is designed for a camera with 28mm mounting hole spacing.

Why two parts?

1. A little bit easier to print.

2. If you have a different camera, just design a suitable top part (STEP files and measurements for hole spacing are attached).

3. Lets you experiment with the angle without reprinting the entire thing—a new top piece only takes 5–10 minutes—while still avoiding wobbly mechanisms. (I picked 50° pitch.)

Requirements:

• 2× M3 Ruthex thread inserts

• 4× M3 machine screws

• 4× M2 Ruthex thread inserts

• 4× M2 machine screws