The shape of it very closely mimics an Xbox controller, with optional fuzzy skin on the back for extra grip, and a cut-out on the bottom for the two usb ports and headphone jack.

The fit is tight enough to hold the console in place for the most part (especially if you really push it in there), but I'd still refrain from using it upside down


Settings used for print:

• supports (Normal) (heavily reccomended)

• 0.2mm layer height

• 15% infill (Adaptive Cubic)

• 2 wall loops

For the fuzzy skin modifier:

• contour

• 0.1mm point distance

• 0.2mm skin thickness

Make sure that fuzzy skin is only applied on the modifier!