Summary

Mod that allows you to move the Z-stop limit switch (aka endstop) on your Creality printer.

Printer Compatibility:
CR-10s
CR-10 V3
Ender 3
Let me know if it does or does not work for more printers.

Installation:

1. Unplug Z endstop
2. Remove the entire T shaped support bracket by loosening (but not completely removing) the 4 hex bolts.
3. With the bracket off the printer, now completely unscrew these four bolts
4. Unbolt the Z endstop circuit board from the old plastic plate by unscrewing two hex bolts.
5. Install the Z endstop to the new 3d printed piece. If the bolt holes are too small, drill them out with a 2.5 mm drill or reprint with larger holes by using the "horizontal expansion" setting in cura
6. Reinstall everything in the reverse order as disassembly.