Overview

This little security anchor attaches to the end of an Elevation Lab TimeCapsule to provide an anchor point for wire loops with in-line fasteners (also known as wire keychains). 

Print Settings

• 1mm layer height
• Tested with PCCF
• Print as oriented in the model (screw heads onto build plate)
• No supports

Additional Hardware

You'll need 2x M3*16 SHSC bolts to replace the originals on the end where you decide to attach the security anchor. Note the screw head holes are quite tight, so apply some force when screwing together for the first time so make sure the threads pull the bodies tight together.