Phone Stand /Holder/ with adjustable tilt angle The prototype is tested on Qidi Tech X-Plus printer with 0.4 mm nozzle. Material: ABS (niceABS Light Grey); Print Settings: Extruder: Flow: 100%; Retraction Distance: 1.5 mm; Retraction Speed: 30 mm/s; Layer: Layer Height: 0.16 mm; Line Width (Body), (Inner Wall, Outer Wall, Top, Bottom): 0.4 mm; Line Width (Flap), (Inner Wall, Outer Wall, Top, Bottom): 0.35 mm; Line Width (Infill): 0.42 mm; Initial Layer Line Width: 130%; Wall Line Count: 3; Top Layers: 5; Bottom Layers: 4; Top/Bottom Patterns: Lines; Fill Gaps Between Walls: Everywhere; Infill: Infill Density (Body): 70%; Infill Density (Flap): 90%; Infill Pattern: Triangles; Infill Overlap Percentage: 50%; Infill Before Walls: Yes; Additions: Z Seam Alignment: Sharpest Corner; Skin Overlap Percentage: 50%; Combing Mode: Within Infill; Build Plate Adhesion Type: Brim; Brim Width: 8 mm; Speed: Infill Speed: 40 mm/s; Wall Speed (Body), (Outer): 25 mm/s; Wall Speed (Body), (Inner, Top, Bottom): 40 mm/s; Wall Speed (Flap), (Inner, Outer, Top, Bottom): 25 mm/s; Initial Layer Speed: 25 mm/s; Travel Speed: 120 mm/s; Minimum Layer Time (Body): 7 s; Minimum Layer Time (Flap): 12 s; Temperature: Printing Temperature (Body): 230 deg; Printing Temperature (Flap): 225 deg; Build Plate Temperature: 100 deg; Cooling: Initial Fan Speed: 20% Regular Fan Speed: 100% Regular Fan Speed at Height: 0.62 mm; Support (Applied only on Body, disabled on Flap) Support Placement: Everywhere; Support Overhang Angle: 30%; Support Pattern: Lines; Support Density: 15%; Support Z Distance: 0.16 mm; Support X/Y Distance: 0.8 mm;