This is a remix of futurescientist1234s work, dont forget to check the original out.

Changes I made are as follows, I used front_sight.stl, made it 15mm short and 5mm taller. I used some old 3d printer bed leveling screw and screw heads. Printed in PETG using 0.28 LH.

EDIT: I am not sure if PETG is the correct material for this print. I am going to try with 0.08 LH PETG one last time.
EDIT2: Printed it with 0.08LH using the same PETG, its very tedious getting this thing in the rails without breaking it. You also have to be very careful not to overtighten it. It works however my scope is garbage and I dont care about it, it might be amplifying the forces going through the scope.

If you make the sights approximately 10 more milimeters taller and have walls 2.5mm thinner on each side you can still use stock sights as well.