This camera support is for Creality K1's camera that, meanwhile is printing, the signal is lost due an overheat.

The original support from Creality is not right because it's too close to heatbed and also the cover doesn't have enough cooling to refrigerate the camera during printing.

Only needs supports in the camera cover. The other doesn't need.

Suitable to print on PETG/ABS but you can do it on PLA also.

Not infill requires.

One M3x20 mm needs to fit the cover with the support. Use the original screws that comes with the camera.

Creality K1

No

Yes

5

Only needs supports in the camera cover. The other doesn't need.

Suitable to print on PETG/ABS but you can do it on PLA also.

Not infill requires.

One M3x20 mm needs to fit the cover with the support. Use the original screws that comes with the camera.