Fantastic Bedside Watch stand with a drawer for cufflinks. Very clean piece lmk what you think! 

This model is originally created by LESFAC50 on the cult s3d website. All credit goes to them! 

Here's their tips 

"I printed the parts with a flat face on the table with the axis of the oval vertical so there is no support needed for the stand and only support needed inside the drawer. So the only post printing operations are getting the support out of the drawer and a little scraping to remove the bit of squish where the inside of the oval was on the bed to allow the drawer to slide in.

This works best with the watch strap closed. If you need the item bigger or smaller just scale in the slicer. I just scaled in 2 planes, the 2 that do not affect the length the watch slides on to. I found I needed to scale less than I guessed."