Blooming Flower
Wide Ingot
AI找相似
打印配置(0)
模型文件(0)
7
6
0
发布时间:2026-04-04 13:24:09
4
0
760描述
标签
模型来源
评论(0)
Print in place flower that blooms. Model size is approximately 75mm diameter x 50mm tall, opens up to 130mm diameter. Pictured model printed at 0.15mm layer height with 0.4mm nozzle on Creality K1 in PLA plus with standard settings. After printing, cut the small bridges between each petal around 10mm (can see the exact location in the slicer preview). Before printing, make sure bed is clean and adhesion is really good as the petals are somewhat weak until the bridge splices are printed. Printing at 0.20mm layer height may cause parts to fuse.
标签
模型来源
原设计地址: 点击查看
CC BY