This is my first attempt at an iPhone 6/s case. It is a simple triangle design with some over layered bumpers that cover the entire edge of the phone. Note: I recommend increasing the infill settings at 100% to increase the strength of the iPhone case. My Configurations Settings: (may vary since these are my settings ) Slicer: MatterControl Printer: Wanhao Duplicator I3 infill setting: 100% Layer Height : 0.1mm (0.2mm look  looks okay as well.) Raft: Yes (but not recommended) Print ETA Time: 4 Hours 35 Minut es HeatBed: yes (not recommended ) --- Support 3D Creator --- If you would like to help me create more cool things and remake stuff, or buy me coffee that would fuel my creativity to do so, you can by clicking here .