Phone Stand /Dog Theme/ The prototype is tested on Qidi Tech X-Plus printer with 0.4 mm nozzle. Material: PLA (Qidi Technology Red); Print Settings: Extruder: Flow: 100%; Retraction Distance: 1.5 mm; Retraction Speed: 30 mm/s; Layer: Layer Height: 0.2 mm; Line Width (Inner Wall, Outer Wall, Top, Bottom): 0.35 mm; Line Width (Infill): 0.42 mm; Initial Layer Line Width: 130%; Wall Line Count: 2; Top Layers: 4; Bottom Layers: 3; Top/Bottom Patterns: Lines; Fill Gaps Between Walls: Everywhere; Infill: Infill Density: 60%; Infill Pattern: Triangles; Infill Overlap Percentage: 45%; Infill Before Walls: Yes; Additions: Z Seam Alignment: Sharpest Corner; Skin Overlap Percentage: 45%; Combing Mode: Within Infill; Build Plate Adhesion Type: Brim; Brim Width: 8 mm; Speed: Infill Speed: 60 mm/s; Wall Speed (Inner, Outer, Top, Bottom): 30 mm/s; Initial Layer Speed: 24 mm/s; Travel Speed: 100 mm/s; Minimum Layer Time (Body): 7 s; Temperature: Printing Temperature: 190 deg; Build Plate Temperature: 50 deg; Cooling: Initial Fan Speed: 0% Regular Fan Speed: 100% Regular Fan Speed at Height: 0.7 mm; Support: disabled;