MP Select Spool Holder - Thinner Mount
StarkTurtle
AI找相似
打印配置(0)
模型文件(0)
0
0
0
发布时间:2026-02-12 06:10:21
0
0
000描述
模型来源
评论(0)
The part that slips in to the clips was almost 2mm wide and I'd have had to sand half of it away to get it to fit. This one simply clips off 1mm of it so that it fits nicely. I'm not sure if our MP Mini is newer and they've changed the size of the clips in later models (ours purchased December 2017) but it's definitely not as wide as the original.
Also, I went back to the original and used Blender to slice out the pins needed. Print 3 of them, obviously.
Print Settings
Printer:
Monoprice MP Select Mini
Rafts:
No
Supports:
Yes
Resolution:
.2
Infill:
12%
Notes:
Printed it upside down for smaller amount of support. Makes the "top" (once it's mounted) not as pretty, but 99% of the time it will have a spool on it, so you can't see it.
Used thicker walls to make the structure stronger: 1.2mm.模型来源
原设计地址: 点击查看
CC-BY