Print this Dice Cannon Tower to randomize your dice rolls when gaming. Suitable for multiple dice, and can roll many at once.

Simply slide the arms into place, and screw in some bolts to hold the cannon in place. I just used some bolts I had laying around, but the diameter of the hole is 5.4 mm.

Use supports where listed, rafts if you have issues with first layer (I used no rafts). DO NOT use supports for the cannon itself, you do not need them. works best when assembled with the cannonball firing away from the dispenser tray.

If you don't feel like printing everything, it also works great with just the main cannon portion placed facing up on the table.

You could scale the model down (no guarantees on fitment and tolerances) if you plan to use only a couple dice, but i use this for Risk, so enough room for 5 dice is needed, that's why it was designed at this size. Everything will fit on an ender 3 though.

Print Settings

Rafts:

Doesn't Matter

Supports:

**Resolution:**

.15-.3

Infill:

**Filament:** any any (cannon and cannon smoke must be hard) any

Notes:

Category: Dice