Use this vice stop on your milling machine. It clamps right on your jaw. Know you can remove parts or fixtures from the vice, and place them back in the same location. Saving valuable setup time.

Print with the holes facing up.

Print two parts. First part tap 10-24 in the center hole (I like to dip the tap in water first) and ream the two outer holes .1865”. Second part ream all three hole .1885” or larger to achieve a nice slip fit.

Hardware: one SHCS 10-24 X 1.250” long. Two dowel pins .1875 (3/16”) X 1.00” long.

Feel free to modify in any way you feel fit.

You can follow me on; Thingiverse @ Mkegadgets Facebook @ Mkegadgets YouTube @ Mkegadgets

Thanks see you tomorrow.

Category: Machine Tools