A pen attachment for the ender 5 pro

No

Yes

0.2 mm

15-20%

when printing, place the top of the part on the print surface. this will maximize success during printing.

After printing is done remove supports and push a pen into the holes. I used an office depot pen for the design so it will most likely not fit any thing wider than 7.8mm. When putting the pen attachment onto the printer lift up the model until it touches the bottom of the head. than tape the side with scotched tape and the top of the head to the top of the heads plate. then place the drawing mat on the build plate(this will keep the surface of your print bed from getting scratched) and clip with large binder clips. After this is completed put the homing peg on top of the limit switch bumper. all you need to do after that is auto home and level the bed so that it doesn't drag the tip into the bed and leaves the pen vertical when it moves. when modelling something for it to draw make the model 0.08 mm tall. When slicing put temperate of bed and head to zero turn off the fans and remove spool of filament from the head before drawing. set layer height to 0.08 and infill to 100%. set speed to 100 mm/s.