A cable hook for an IV-stand stopper ring. I have a habit of balancing cables and wires on anything that can hold them. In this particular instance, I can't have the cables hanging and thus have been balancing them on a screw head of one of one the stopper rings. So instead of continuing this and have the cables constantly fall down I made a cable hook that goes on top of the ring, using the main column, ring and its tightening screw for support.

Print time: 20 minutes
Filament used: 1.31 meters of PLA

Estimated material cost (PLA): ~0.12 €
(Calculated from 200 m spool with a price of 17,99 € ≈ 0.08995 / m)

FlashForge

Finder

Yes

Yes

Standard

15%