Summary

VR Bunny tricks the sensor to keep VR up and running when you take off the goggles.

Don't you hate it when Your VR session crashes because you got the Error Message...
"𝒀𝒐𝒖 𝒂𝒓𝒆 𝒏𝒐𝒕 𝒘𝒆𝒂𝒓𝒊𝒏𝒈 𝒚𝒐𝒖𝒓 𝒉𝒆𝒂𝒅𝒔𝒆𝒕. 𝑪𝒐𝒏𝒏𝒆𝒄𝒕 𝒚𝒐𝒖𝒓 𝒉𝒆𝒂𝒅𝒔𝒆𝒕."
Because you took a 2 min break?
Or you are setting up the VR and you took too long to put on the headset?
Most VR goggles have cameras near the lenses looking back at you.
Gone are the days of holding something inside of the headset to trick the VR driver into believing that you have it on your face.

With my handy dandy VR Bunny headset mask now you can put the fake face onto your headset while you take a break.
Simply put the face into the foam headset gasket and hook the tabs over the front of the headset.

Mine is sized for HP Reverb. The name Bunny came to me after I printed it.
I needed to add stick on foam pads on the ears to tighten up the grip.
Better for the print to be a little bit loose than too tight.

Edit: Use file - VR_mask_v3.stl
I had to scale the model wider to better fit my headset.
The face was too far away from the lens, so I changed the clip.

OnShape - CAD file provided so you can modify the model to fit your device.
https://cad.onshape.com/documents/5170341bea1efac5bd8e3689/w/7221295d46b6c1bd419ddc8e/e/0918a945f0e1b5d9a196a8d1?renderMode=0&uiState=67df1848d0088813c57cb460