This is an airbox lid made for the Centurion/Generac 5000w generator. I could only find the entire assembly for around $30-50 and not just the lid (which someone who looks a LOT like me threw away >.>).

Inside dimensions of the cover are 158.75mm x 266.70mm x 20mm. Measure the depth (the 20mm) to make sure this gives your air filter assembly enough clearance as this can change from year to year, model to model.

To attach to the assembly, I used two (2) self-tapping screws going from the inside out in the middle of the top and bottom, took a small grinder to the end of the screws to remove point, then secured them to the existing tab on the assembly with a small zip tie. As the unit isn't in direct heat exposure, there shouldn't be any worry of melting but....

long inhale I am not responsible from any fire, damage, death, dismemberment, or any bad time had in general with this creation. If you print this and use it, this is at your own risk.

In THEORY, this should also fit models like the Generac GP5500, GP6500, GP6500E portable generators.

Creality

CR-10S

No

No

25%