Ok. So here is a design for holding an Xacto blade at various heights. It's main purpose was made for work in clay, but you could adapt it for use with slicing other material, or marking things with a knife I suppose.

Things to keep in mind:

• I made this for an Xacto knife that I own. It's a tight fit. I used digital calipers to design this which were a big help. I believe the diameter of my knife is 9mm, so I made it a 9.25mm diameter because that is my printer tolerance to get it snug for 9mm (refer to pictures for exact measurements I took in Rhino for the design). You will want to print the test piece, or segment of the test piece before printing the tower (you can sink it into the bed a little more if you wish to speed it up). Take note of any scale changes you have made to the test piece and write that down. The test piece is an exact slice of the original file.
• If you make any change in scale to the tower that holds the blade portion, you will need to make the same scale change to the holder. Don't forget to do that or else it will not fit. I left a .5mm gap on all sides of the holder, which gives a total of 1mm for left/right and top/bottom spacing.
• This design needs no supports at all anywhere. Print the tower on its side. The stand can be flat. Toss some strong glue or super glue after doing a test fit with it. Done.
• The spacing of the cuts is ~12mm. This is the closest I could get the inserts to sit where it felt strong enough between each snap in segment.
• I printed this on a 310mmx310mm Ultrabase glass bed. It's pretty close but there's room for slight change in scale if you need to increase it.

I printed with 25% infill, 0.2mm layer height using a 0.4mm nozzle. My wall/perimeter count was 4 walls everywhere.

Print Settings

Printer Brand:

TEVO

Printer:

Rafts:

No

Supports:

Resolution:

.2mm layers

Infill:

Filament: Enomaker PLA Red Silk

Notes:

Category: Art Tools