Miscellaneous magnetic locker holder for school.  Holds 2 pens, a post it note, and a clip to hold whatever needs to be hung of importance.

The magnets I used are very strong magnets that I purchased off of Amazon.  They fit perfectly on the back in the cut outs.  Just add some super glue, plop them in, and wait for them to dry and your good to go.

Here is the link:   Magnets -  https://a.co/d/9LaAMke

You need to use supports for this.  I used organic which made it easier to remove.  The clip was tough but with a small knife you can cut out the supports for it and unstick the clip part.

Print it on it's back, with the magnet holes down against the print bed.