Converted my Maker Select Plus to a RAMPS install, unfortunately this required a new LCD. I went with the RepRap Full Graphics Smart Controller.

Printed the case here: http://www.thingiverse.com/thing:87250

Unfortunately I needed to mount it, so I designed this bracket to clip on the top.

Print two, each one will screw into the bottom hole of the case, holding it remarkably well.

Print Settings

Printer Brand:

Wanhao

Printer:

No

Supports:

0.25

Infill:

Notes:

Tolerances are very tight, might need to scale up a percent or so.