This is a cable holder/stopper for 6mm diameter cables. NOTE: A 3mm threaded insert is needed to complete the part.

-Desinged Dimentions:

Main Hole Dia. - 6.4mm

Side Hole Dia. - 4.8mm

Small Outer Dia. - 14mm

Large Outer Dia. - 16mm

Height - 20mm

*Actual dimentions may vary due to plastic attributes.

-Build & Use Instructions:

Aquire a 3mm threaded insert (you can use lager sizes but this fits better with the model)

Print your cable stopper

After printing heat up and press fit the thread insert in the side hole (Soldering Iron works best)

Pass the cable through the large main hole

Screw a M3 (3mm Dia) screw on the side. (Don't screw too tight or you may drill into your cable and cause shortcircuit)

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

0.2

Infill:

Filament: PLA or PETG

Category: Parts