3uP 3D Printer Cable Chain System (STRONGER)
sunette03
AI找相似
打印配置(0)
模型文件(0)
0
0
0
发布时间:2017-09-14 21:57:13
0
0
000描述
模型来源
评论(0)
Summary
I made the holes for the screws thicker, as I was having issues with them snapping off too easy.
I recommend PETG as it's really good for "Snap Fit" parts. However, ABS should work just as good. PLA tends to sag over time, so I don't recommend it.
Use supports if the bridging doesn't come out as expected. Just be careful removing them.
Print Settings
Printer Brand:
Wanhao
Printer:
Wanhao Duplicator i3 V2
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
25%
Notes:
I recommend PETG as it's really good for "Snap Fit" parts. However, ABS should work just as good. PLA tends to sag over time, so I don't recommend it.
Use supports if the bridging doesn't come out as expected. Just be careful removing them.
Post-Printing
Step 1
Clean up any loose filament that was made during the "bridging".
Step 2
Snap the chain pieces together.
You will need about 30 of them for the 3uP.
模型来源
原设计地址: 点击查看
CC BY-SA