The Falcon 120 drone has a vulnerable camera, designed a little observatory style dome to offer some protection to the camera.

Mount by drilling holes in print and using M2 nut & bolt to attach to the two slots under the tabs on each side of the camera dome.

V3 allows the RX board to be mounted on the back of the dome, this needs a different antenna like the Triumph pictured to free up enough room. The nuts are mounted on the top for base mounting - they are tight fit so as to lock against the side.

Must be printed with supports due to dome and probably a raft to help give it a good bottom to the print.

x6b rx fits to the back of hood with M2 nut and bolt. Use the "hood pocket" to convert the mounting to work with a a8s rx

Print Settings

Printer Brand:

Printrbot

Printer:

Rafts:

Yes

Supports:

Resolution:

0.2

Infill:

Category: R/C Vehicles