This model includes a lid and container to house a Gimbal Proximity Series 10 beacon.

To better highlight your beacon's capabilities, you can also print a 50mm x 5mm topper (just a simple cylinder) and combine it with your logo or any other model. You can see our logo was added as a topper and just super glued in place. Makes client demos much easier and obvious.

Doesn't Matter

Doesn't Matter

These models can print side by side and take about an hour with no supports or rafts needed.

Size the beacon-gimbal-case-top.stl to 55.44mm wide

Size the beacon-gimbal-case-bottom.stl to 53.55mm wide

This will then securely house the beacon and allow just enough friction between the top and bottom for a tight seal.