I made this thing for holding toothpaste and toothbrushes. It is small enough to print on my monoprice mini delta.

I printed with no supports, 30% infill, 5 tops, 4 bottoms, at .2mm layers. That may have been a little overkill, but for some reason, that's what I have my defaults set to. I would probably print with 15%, 3 tops and 3 bottoms next time.

Oh, It needs scaled by 2540% since somebody decided to use inches for units that day, rather than mm (it was me...)

The screw holes are made for #6 screws.

It seems to be working well so far.

I made this in fusion360, and have included the f3d archive for your editing pleasure. I also exported it to a sketchup file, as well as an obj, for those who like their printers a little more closed-source.

Happy printing. :)