Iris V1 Motion
Husky World
AI找相似
打印配置(0)
模型文件(0)
0
0
0
发布时间:2026-02-25 16:27:29
0
0
000描述
标签
模型来源
评论(0)
Took one apart to play with and lost the case. It is not perfect but the fit is good. I added 2 holes to the back for some type of mount later on.
The board is held in with hot glue.
Print Settings
Rafts:
No
Supports:
Doesn't Matter
Resolution:
.022
Infill:
20%
Filament:
eSun petg
Notes:
I did not use support, but probably should have for the cone. The snap might work better with ABS. PETG is kinda stiff.
Due to not using support the cone wasnt great. I used some bondo to help it out a bit. I then shot some flat black on it. Its not dry in the picture.
标签
模型来源
原设计地址: 点击查看
CC-BY