There are two versions of the sheath. I printed both in PETG and they came out pretty well. The vase mode version is a tighter fit than the normal one. Both versions should be printed with the tip facing up

• Normal mode:

  • 0.6 nozzle

  • 0.3 layer height

  • no supports needed

  • 2 wall loops

• Vase mode:

  • 0.6 nozzle

  • 0.24 layer height

  • 150% outer wall

  • 0 bottom layers

  • 40 mm/s  outer wall speed (this was important, at higher speeds I got more gaps in some areas)