Holds my wide angle pi camera (http://www.ebay.com/itm/321424952350?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT). I mount this between the metal frame and the front plastic by loosening the front center screw a little, slipping it between and tightening it down so it's just pinched there.

Print Settings

Rafts:

No

Supports:

Notes:

I printed in ABS and it's a tight fit for my camera: http://www.ebay.com/itm/321424952350?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT. It'll have to be modified for others. And probably enlarged 1% for PLA.

The overhang of the slot is at a steep enough angle that my printer can print it without support, but I print it slowly.

How I Designed This

Designed in AutoDesk Fusion 360. Here's the public link to the design: http://a360.co/1FTmHZv