I did this design to help to level Shelf, it should be helpfull to nivelate o compensate a bad support.

Features:

• The Nut can be printed in a one piece.
• Dont need support, it is included into the same design, after print you need to break the little supports turning the regulator.
• Regulator increase the length until 14mm.

Try the design, comment your feedback, and enjoy it!

Print Settings

Printer:

Prusa Bear i3 Mk3s

Rafts:

Supports:

No

Resolution:

Infill:

20%

Filament:

PrintALot PLA

Silver and Stone White

Category: Household