Cup Holder Cap to keep my old Dachshund feet out of the empty cup hole in the recliner couch.

Micro Maker delta

Yes

No

.8

13%

PETG with no strings.
I Use Cura 15.04 noted default settings for PETG and any other type filament were for 2.85 mm. When you change to 1.75mm the flow rate never changed.
So I changed it from 107 - 125 and back to 113 for now it seems to work very well.
only problem is if doing very thin 2mm round flanges it seems to make defect of the circle.
I set layers to .8mm also played with speed settings at first. but Notice when it was printing what ABS would do to perfection this would string out. 2mm flat service. I noted the flow was not enough to put down the layer. so it would lay a long string. that is were I thought to increase the flow values.